Edwards 2-3/8" Tube Bender Die for 10-Ton Tube & Pipe Bender XP3 The JET JPS-10 ProShop Table

The JET JPS-10 ProShop Table Saw delivers the cutting precision

When feed rate stays balanced and scratch patterns are minimized

The cast base guides material away from the blade as you work

Vortex Cone Separation System

Stainless Steel Material Filter

Edwards 2-3/8" Tube Bender Die for 10-Ton Tube & Pipe Bender XP3 The JET JPS-10 ProShop TableEdwards 2 3 8" Tube Bender Die for 10 Ton Tube & Pipe Bender The Edwards 2 3 8" Tube Bender Die fits the Edwards 10 Ton Tube & Pipe Bender, run off an Edwards Ironworker with the PowerLink System. A brass follower supports the tube through each bend and helps the die hold up over time. This die is available in two radius sizes with a choice of 90 or 180 maximum bend. Brass follower extends die life Precision machined for consistent bends Fits Edwards